Precautions for use of cement sand blasting gun

1. Before spraying for the first time, it is necessary to clean the residue in the coating channel, add the release material into the gun pot, and try to filter the inside of the spray gun once to ensure cleanliness
2. Adjust the appropriate spraying air pressure during spraying
3. Control the angle and distance between the spray gun and the spray part during spraying
4. After pulling the trigger before pre-spraying, the first gear can be used for dust blowing
The paint flowing through the nozzle at the second gear runs through the train and sprays air at the same time
According to the paint flow used by customers, adjust the seasoning plug to control the process of the gun needle, and freely adjust the paint flow
7. Adjust the size and width of atomization spray range according to the spraying range of customers to achieve complete spraying effect
8. After use, clean the air flow cap and nozzle in time (first pour out the paint in the gun, then add the diluent and shake it
Pull the trigger and try to spray the residual paint inside the spray gun. Then remove the air flow cap for cleaning. If the air flow cap is too dirty, soak the diluent for a period of time before cleaning. Pay attention not to damage the hole on the air flow cap during cleaning. After the air flow cap is removed, protect the nozzle from being damaged. The atomization effect will be affected by poor cleaning, nozzle bruise and air flow cap hole damage.)

?