The use of gun foam glue and steps

The use of gun foam glue and steps:

（1） Take the foam gun and clean it with polyurethane cleaning agent to ensure smooth flow;

（2）Take the foamed glue, hold the middle of the tank tightly with your hand, shake it vigorously along the transverse direction of the tank for at least 15-30 times, make sure that the prepolymer in the tank is fully mixed;

（3）Remove the protective cover of the valve on the thread ring of the gun foam glue, remove the cleaning agent on the foam gun, and install the foaming agent tank body on the interface of the foam gun along the thread;

（4）Hold the handle of the foaming gun firmly, ensure that the tank is placed on the top, the foaming gun is under the tank, and open the flow regulating valve at the back of the foaming gun;

（5）The head of the gun is aimed at the bottom or inside of the part to be filled, and the trigger is gently pulled to start the construction. The flow rate can be adjusted to the appropriate flow rate through the flow adjusting valve behind the foaming gun;

（6）After a can of spray, if you want to fill, you can immediately take off the empty tank, in accordance with the method of the third point to reload the foaming agent, to continue the construction;

（7）After the completion of construction, timely remove the tank, put on a special cleaning agent to clean the foam gun, so as to avoid the residual material curing blockage damage foam gun.